![]() ![]() Use rubbing alcohol to clean the buttons themselves and never touch the board with your fingers. Same for putting it back in the lager side of the wheels axle is for the 3rd button or Mouse Wheel Button and the thinner side goes into the green gear inside the wheel housing it fits like a puzzle so be gentle. ![]() You will need a Small Philups Screw Driver (Glasses Screwdriver works fine) after that the case can come off if your cleaning the wheel the board and the wheel will have to come out a bit before being able to remove it. the last one is under the the longer U or Smile Shaped sticker were the heel of your hand would sit naturally on the mouse. If you are looking at the optic ( red light) side you will see 3 spots that are raised these are buffer stickers and underneath them are the screws there are 3 in all the first 2 are right were your fingers would rest on the left and right side of the mouse click buttons. It states, The receiver and the optical mouse are preconfigured at the factory to be paired with only that specific wireless mouse for security reasons. 30-07-2012 The movement is especially helpful. Hello this is for the mouse that comes with the new computer, straight out of the box. All you need is to setup the Wireless Mouse, HP X3000 Wireless Mouse - Setting up the HP X3000 Wireless Mouse. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |